LabelScan - Vision Inspection SystemSource: Peco InspX
Typical applications include direct mounting in roll fed and sheet fed rotary labelers where the LabelScan will inspect each container:
To confirm that the proper label has been applied
To detect any container with a missing label
To inspect each label for tears, ripples and irregular applications
To measure minimum skew at lap point
Precision: LabelScan "learns" the proper label and location by assembling a statistical model of the target and then comparing each picture to the model. At the option of the user, LabelScan can eject products with extremely small differences or an acceptable amount of leniency.
Control: LabelScan inspection can be targeted on specific parts of the labeled package by defining the appropriate "regions of interest (ROI)." In addition, a tolerance setting enables smaller defects to be either accepted or rejected by the user.
Changeover: LabelScan stores multiple configurations from prior label runs for the same label. Each of these configurations can be easily accessed as a new run of an old labeled product commences. If differences require ther creation of a new model, LabelScan can assemble a new model in seconds.
Ejector / Diverter Options: LabelScan can be configured to interface with existing ejectors or work with the full range of Peco ejectors such as the high speed EJH-ST or the unique SlimLine flexible rail system .
Versatile: LabelScan's single camera system frequently provides full circumference inspection of round containers by dividing each camera shot into multiple images and processing each separately. Optional multiple camera configurations allow for front and back inspection.
Ejector Control: LabelScan includes Peco's Multi-Trac ejector control system that assures accurate tracking of the mislabeled container from the discharge of the labeler to the ejector.
Easy to Mount/Install
LabelScan includes all necessary hardware for a complete installation.
Camera - sized for the application.
Lights - specified for the application.
Bracketry - appropriate for the installation.
Sensors - Includes timing sensors as required for inspection and ejection.
Timing - Includes encoder for conveyor speed synchronization to assure accurate container ejection and variable speed inspection.
Power Requirements: - 115 VAC 50/60 Hz
Operating Temperature: - - 6 C to 40 C
Speed: - Up to 1,000 cpm standard
Air Pressure: - 60 to 80 psi